Project update
I've found a Remington rifle stock at the NESSCI swap meet that was held yesterday, it's perfect for me to finally try my hand at fitting my adjustable comb hardware to.... and I don't need to ruin my BDL stock trying.
I've started by cutting a card template and sticking it to the centre line of the comb with tape on both sides making a hynge so I could trace an accurate line to cut along.
I've then cut the first two angled cuts with a hacksaw because it cuts straight and thin.
Then I used a hand scroll saw to cut the radius corners and switched back to the hacksaw for the straight horizontal cut.
A little carefull sanding and it's shaping up well.
- 2015-09-14 21.27.03.jpg (1.33 MiB) Viewed 9068 times
I've still got some work ahead of me because this stock is from a adl ? with no provisions for a floor plate so I'm going to have to cut and shape that area to.