pmomd wrote:I'll strip and clean the bolt, hadn't thought of doing that after - just in case.
Primer looks like any other spent primer.
No rubbish in the chamber or stuck in the neck area?
pmomd wrote:I'll strip and clean the bolt, hadn't thought of doing that after - just in case.
Primer looks like any other spent primer.
Oldbloke wrote:I was thinking along the lines of a hair dryer or a heat gun as mentioned earlier. All academic bs now bs now . Lol
Jack V wrote:Oldbloke wrote:I was thinking along the lines of a hair dryer or a heat gun as mentioned earlier. All academic bs now bs now . Lol
Ok I see . It may have worked .
Look I have spent a life time with guns and been trained by three Government jobs with weapons and spent many many hours watching gun smiths and armourers work . Been a gun owner , hunter , reloader and experimenter for 45 years and a bullet maker for about 25 years . You can't do that and not know a thing or two . It hurts when you give people your hard earned knowledge and they don't even have the decency to say thanks properly .
Westy wrote:Hang - on here
If this keeps up I'll bring that photo out again
Westy wrote:Hang - on here
If this keeps up I'll bring that photo out again
Westy wrote:Hang - on here
If this keeps up I'll bring that photo out again
bigfellascott wrote:I was going to suggest he do the same thing that you did Jack but to me it was an obvious solution (I couldn't see any other way of getting it out to be honest) so I figured he would do that anyway (then you suggested it) which saved me from pointing out the bleeding obvious.
Chronos wrote:You serious? a bloke comes in with a problem, several offer advice and you want special thanks specifically aimed at you?
maybe you'd like your own thanks thread so no one accidentally gets thanks that was yours
Warrigul wrote:No rubbish in the chamber or stuck in the neck area?
pmomd wrote:Fixed the bugger
Can't really see anything wrong with the brass, nothing has split or separated.
Jack V wrote:Don't ever expect any further help from me.
tom604 wrote:he thanked all, all good.
Oldbloke wrote:Personaly, I think continuing to post images and comments along those lines is unacceptable behaviour on a public forum.
newsteadvic wrote:Although there is obviously debate about the value of pressure signs, are there any of the obvious pressure signs - extractor mark imprints, flat primer, gas leak past primer or loose primer?
Is the case head at the web diameter similar to others in the batch?