You could try -
Made by Total Solutions Engineering www.tsengineering.com.au
Phone 0733553115 Fax 0733556776
Prop.name is Tony Argent -- this is the same company that makes --
MAB Barrels in Australia
RoginaJack wrote:You could try -
Made by Total Solutions Engineering http://www.tsengineering.com.au
Phone 0733553115 Fax 0733556776
Prop.name is Tony Argent -- this is the same company that makes --
MAB Barrels in Australia
Bullbarrel033 wrote:I shot my way into A grade with a $300 Omark 44. Made a lot of shooters angry, who had thrown $5k at there RPAs and Barnard's etc.... I love them, I'm in the market for another because I hate the new plastic fantastic s**t!
Wyliecoyote wrote:Omark bolt heads weren't all that hard and coupled with a 4140 barrel that had the locking lugs cut into it, the two surfaces were not that slick and prone to wear hence the notoriously heavy bolt lift. The fix i did was clean up the lugs and the face of the bolt head and heat treat to around 40 RC. Remove bolt handle and heat treat the cocking helix to 35 RC. They are dead soft bolt bodies of chromemoly at around 29 RC. The adapter was treated to around 35 RC, the cocking piece is already in the high 50s RC. The whole lot combined means you can cycle the action with one finger.
in2anity wrote:Wyliecoyote wrote:Omark bolt heads weren't all that hard and coupled with a 4140 barrel that had the locking lugs cut into it, the two surfaces were not that slick and prone to wear hence the notoriously heavy bolt lift. The fix i did was clean up the lugs and the face of the bolt head and heat treat to around 40 RC. Remove bolt handle and heat treat the cocking helix to 35 RC. They are dead soft bolt bodies of chromemoly at around 29 RC. The adapter was treated to around 35 RC, the cocking piece is already in the high 50s RC. The whole lot combined means you can cycle the action with one finger.
I would love to fix mine like this - but I'm not prepared to miss some shoots while i wait lol