A Marlin XLR 30/30 Review

Bolt action rifles, lever action, pump action, self loading rifles and other miscellaneous longarms.

Re: A Marlin XLR 30/30 Review

Post by Tank » 29 Jan 2020, 10:36 pm

Thanks in2anity!
I have a selection of jacketed and cast (commercial and range trash home cast) projes and a goodly supply of Trailboss, 2207 and 2208. Sage advice bloke! :thumbsup: I’m not expecting to reinvent the wheel but it’s great to have a place to start and realistic expectations.
I’m hoping the FTX’s might ‘carry up’ a little better than the regular cooking model FP’s....but I’m certainly not looking to push the envelope with any of them.
Hoping to close in on 2,100fps with the 160’s....(?) but not important. Extraction of every last drop doesn’t interest me.
Looking forward to a handy, relatively hard hitting little rifle that I can enjoy in equal parts lobbing cast projes at below 1,400fps (pistol club velocity limit) on the range.
Have you experimented with Trailboss much in2anity?
Regs,
Tank.
Keep calm......and hold centre of mass.
User avatar
Tank
Lance Corporal
Lance Corporal
 
Posts: 207
South Australia

Re: A Marlin XLR 30/30 Review

Post by pomemax » 30 Jan 2020, 12:12 am

Shootermick wrote:Nice rifle and good review mate. Just wondering, where the mag tube dovetails to the under side of the barrel, is there any movement in the mag tube? And where it comes out of the forend? I’ve got a 336 BL and you can move the mag tube just a bit, the dovetail itself is tight, but the screw that goes through the end of the mag tube seems like it could be tighter, but I can’t get any more out of it. On the other hand, some people have said that this is normal.?

Mine is the same
pomemax
Warrant Officer C2
Warrant Officer C2
 
Posts: 1165
New South Wales

Re: A Marlin XLR 30/30 Review

Post by in2anity » 30 Jan 2020, 7:43 am

Tank wrote:Have you experimented with Trailboss much in2anity?
Regs,
Tank.


Yeah mainly under commercially bought (hard) cast lead projectiles - but I have never "cast my own". With the Marlins (and their microgrooves) I never got peak accuracy out of TB. Accuracy was adequate, and fine for offhand shooting (such as practicing for lever metallic silhoutte), but I always got better groups using a comparitively slower powder, like a reduced charge of AR2207 (in the case of the 30/30).

My 1892 Winnie 32-20 just loves Trail Boss however - it groups best with it.

There might be a link between the ballard cut rifling and TB... I've never researched that line of thought. Bladeracer might be able to offer some insights here as he has a lot of experience with levers also...
At what point does lack of maintenance become patina?
User avatar
in2anity
Lieutenant Colonel
Lieutenant Colonel
 
Posts: 3048
New South Wales

Re: A Marlin XLR 30/30 Review

Post by marcus_pearce07 » 20 Feb 2020, 6:23 pm

Looks like its a really, really nice gun. i've been researching a bit but i cant find and sturdy price range, do you reckon you could tell me the price range for the 30-30. was also just wondering if you know if the dark series affected performance at all, or just changes the look. be a great help if you know. :D
marcus_pearce07
Recruit
Recruit
 
Posts: 3
Queensland

Re: A Marlin XLR 30/30 Review

Post by in2anity » 26 Feb 2020, 11:23 am

marcus_pearce07 wrote:Looks like its a really, really nice gun. i've been researching a bit but i cant find and sturdy price range, do you reckon you could tell me the price range for the 30-30. was also just wondering if you know if the dark series affected performance at all, or just changes the look. be a great help if you know. :D

They are overpriced at around $1700AUD RRP. Look for a second-hand one as they depreciate faster than most other guns; you often see near new ones under a grand.

Yes I'd be willing to bet the Black Edition would group well due to the lack of barrel bands.
At what point does lack of maintenance become patina?
User avatar
in2anity
Lieutenant Colonel
Lieutenant Colonel
 
Posts: 3048
New South Wales

Re: A Marlin XLR 30/30 Review

Post by StraightWhiteMale » 26 Feb 2020, 11:26 pm

I want that Marlin mate but in a 45-70!!!
StraightWhiteMale
Lance Corporal
Lance Corporal
 
Posts: 167
Queensland

Re: A Marlin XLR 30/30 Review

Post by wrenchman » 27 Feb 2020, 12:44 am

when the marlin xlr come out i had read that it was made with the hornady flex round in mind and that is one of the hi end guns and it does seem to shooting well for you
i have a old 336 that was gifted to a freind it was in the rafters down in the basement of a guys grandfather rust all over it i got it tore down soaking in oil for him.
i dont think it has seen day light in 30 years that is one thing you wont have to worry about with that ss that is a nice looking gun
wrenchman
Warrant Officer C1
Warrant Officer C1
 
Posts: 1345
United States of America

Re: A Marlin XLR 30/30 Review

Post by in2anity » 27 Feb 2020, 6:56 am

wrenchman wrote:when the marlin xlr come out i had read that it was made with the hornady flex round in mind and that is one of the hi end guns and it does seem to shooting well for you
i have a old 336 that was gifted to a freind it was in the rafters down in the basement of a guys grandfather rust all over it i got it tore down soaking in oil for him.
i dont think it has seen day light in 30 years that is one thing you wont have to worry about with that ss that is a nice looking gun


I've bubbad it a bit now TBH :P I free floated, then RTV bedded the forend. Helps with consistency over longer strings.

Right now I've also got a JM 30AS that received the same RTV treatement; at closer distances that gun is just as accurate. However the XLR is a superior open-sighted gun - better for comp.
At what point does lack of maintenance become patina?
User avatar
in2anity
Lieutenant Colonel
Lieutenant Colonel
 
Posts: 3048
New South Wales

Re: A Marlin XLR 30/30 Review

Post by marcus_pearce07 » 27 Feb 2020, 6:33 pm

hey in2anity

i was just wondering how you can get that sort of bluey-grey design on your stock. everything i've searched up just shows the default brown wood design

thanks
marcus_pearce07
Recruit
Recruit
 
Posts: 3
Queensland

Re: A Marlin XLR 30/30 Review

Post by in2anity » 27 Feb 2020, 7:08 pm

marcus_pearce07 wrote:hey in2anity

i was just wondering how you can get that sort of bluey-grey design on your stock. everything i've searched up just shows the default brown wood design

thanks


A mixture of horse semen and gold dust panned from the Macquarie river... nah jokes mate - that’s just how it came from the factory :thumbsup:
At what point does lack of maintenance become patina?
User avatar
in2anity
Lieutenant Colonel
Lieutenant Colonel
 
Posts: 3048
New South Wales

Re: A Marlin XLR 30/30 Review

Post by solarpak » 01 May 2020, 11:07 pm

All the second hand ones i have seen are around the 1200-1500 price point ........you would be very lucky to score a VGC or better unit for under $1K.
A good mate has a XLR in 3030 and its his go-to goat hunting rifle and had taken many stinkies with it over the years. I was looking for one but opted for a Howa Mini in 7.62x39 - ballistically very similar to the 3030 . My mate with the XLR also bought a Mini Action in the Russian calibre and for ammo, we sourced a crate of 1200 steel cased Norinco ammo, pulled the projies and reseated 123 gr Hornady ZMax and 125 gr Sierras. Both loads shoot under an inch for three shots all day in both Mini Actions......and i dare say we have enough ammo to see us out a while.

C.
solarpak
Corporal
Corporal
 
Posts: 355
South Australia

Re: A Marlin XLR 30/30 Review

Post by in2anity » 02 May 2020, 9:53 am

solarpak my Marlin 3030 was my goto hunter for years. And indeed they won't let you down. However Marlins are a little weighty by modern standards - notably heavier than a whippy sporter wearing plastic. And cartridges like the 762x39 and 300bo do essentially the same thing, just in a smaller package. 762x39 is awesome - we have a club Lee-Enfield 762x39 conversion that holds its own even on the 200m mound. Meanwhile, these days I use a little 16" Ruger 300bo out in the paddocks. Extremely light and pointable, and hits pretty much the same as the old 3030. It's also more consistent than a lever - my handloads will consistently group into close to a minute. Best part about the 300bo is I can reanimate my expired 223 comp brass into the 300bo! That and I consume the uber-cheap, Speer .308” light hunting bullets which do great!

625B8C1C-1421-40FD-8FFE-CC3CF5DFA40F.jpeg
Compact 16” Ruger 300bo - very good hunting package
625B8C1C-1421-40FD-8FFE-CC3CF5DFA40F.jpeg (105.19 KiB) Viewed 3231 times
At what point does lack of maintenance become patina?
User avatar
in2anity
Lieutenant Colonel
Lieutenant Colonel
 
Posts: 3048
New South Wales

Previous

Back to top
 
Return to Centerfire rifles