Metho is ok as long as your not going to moly coat as it does leave some residues that will upset the coating process . Other than that metho will do .northdude wrote:Ok meths no good? I use meths in bore if ive used an ammonia cleaner in it
Metho is ok as long as your not going to moly coat as it does leave some residues that will upset the coating process . Other than that metho will do .northdude wrote:Ok meths no good? I use meths in bore if ive used an ammonia cleaner in it
northdude wrote:Ok meths no good? I use meths in bore if ive used an ammonia cleaner in it
northdude wrote:yea it gets a good going over with meths then hoppes 9 then an oily patch
JohnV wrote:northdude wrote:yea it gets a good going over with meths then hoppes 9 then an oily patch
With Hoppes no 9 avoid breathing the fumes as it's got methanol in it and it's very bad for you .
Wear a mask while cleaning with any bore solvents . I never did when I was young because we just did not know , no internet back then and I think I have some lung damage . https://www.hoppes.com/on/demandware.st ... 2e5830.pdf
northdude wrote:JohnV wrote:northdude wrote:yea it gets a good going over with meths then hoppes 9 then an oily patch
With Hoppes no 9 avoid breathing the fumes as it's got methanol in it and it's very bad for you .
Wear a mask while cleaning with any bore solvents . I never did when I was young because we just did not know , no internet back then and I think I have some lung damage . https://www.hoppes.com/on/demandware.st ... 2e5830.pdf
Damn Ive been using it as aftershave