Earthing loading presses

[vmaxaust]

Has anyone earthed their presses& loaders against static electricity?i have often wondered if this neccessary& would it make powder flow any easier?your thoughts would be appreciated.

I earthed my presses. Don't know if it made any noticeable difference although definitely less of that powder climbing the powder drop in my Hornady LNL Progressives. Ran a single wire from presses to a mangled steel target frame shoved into the soil at the back of the garage where I load.

[Oldbloke]

Soooo, I earthed my steel topped bench to the steel garage frame yesterday. Later to be sure will earth the shed using a copper pipe in the ground.

Done, 1/2" copper pipe rammed down about 16" into ground. Should work fine.

[auriga3]

Thanks for the replies gents,especially from Stix