Case Neck Turning, for a Tight Neck chamber

Reloading equipment, methods, load data, powder and projectile information.

Re: Case Neck Turning, for a Tight Neck chamber

Post by Homer » 14 Nov 2018, 4:55 pm

G'Day Fella's,

I finally got the 6.5x47 Lap cases/necks finished
As I suggested, this barrel has a minimum spec neck diameter chamber but not a tight neck one.
So, all I'm trying to achieve here, is to uniform the case neck thickness, nothing more.
The initial neck turn, shows a similar pattern with all the cases necks.
That being, the case mouth area, being a bit thinner than the lower section?

Here's some images;
DSCN3114.JPG
DSCN3114.JPG (1.05 MiB) Viewed 3795 times

DSCN3115.JPG
DSCN3115.JPG (605.62 KiB) Viewed 3795 times

DSCN3117.JPG
DSCN3117.JPG (1.24 MiB) Viewed 3795 times

DSCN3119.JPG
DSCN3119.JPG (903.74 KiB) Viewed 3795 times


I'll give these a rip down range, and see what occurs.

Onto the .338 Lap Mag next............

D'oh!
Homer
Homer
Corporal
Corporal
 
Posts: 340
Australian Capital Territory

Back to top
 
Return to Reloading ammunition