Hi guys,
Can someone tell me, to neck down .308 brass do you just put it through a 7mm-08 full length sizing die?
Is that all? Just a single pass and it's done?
Or do you need to do any intermediate steps?
Thanks.
Aster wrote:Like Yoshie mentioned, the necks will pick up a little thickness which can cause chambering issues in some rifles, but most accept them no problems.
Lorgar wrote:I've resized .308 down to .243 in the past and could do it in a single pass with no problems
Lorgar wrote:I can upload a picture when I'm home later... I've resized .308 down to .243 in the past and could do it in a single pass with no problems, and .308 to 7mm-08 is less of a change than that.
Carter wrote:That's a fair step down in one go. I know a bloke who does it the same but does .308 > 7mm > .243
No need for the intermediate 7mm die in your experience though obviously?