Hi, what do you do for your reloading dies to prevent rust? I have my press in a small shed, and checked it the other day and there is a slight bit of rust in places on the outside of it. I had a light towel draped over the press on the bench, with the die still in the press, and left the towel over it for too many weeks. Been so busy and should have stored the die properly.
In general, should you spray something like WD-40 onto and into the die before putting it back in its plastic case, and if you do, do you need to clean the water-repelling oil from the die before doing another session of reloading? Thanks.