Received my dies today (yet to get a press) and have been fiddling with them, polishing crimp faces etc.
Looking at the QT die, I think there's a fault with it. There is a gray plastic insert in the bottom that has a shoulder machined into it. The inner shoulder is substantially smaller than a casing and wont allow one to be pushed (by finger) into the die.
My guess is its supposed to be a plastic o-ring holder and is unfinished? Theres mention of o-ring on the lee site.
If its supposed to be a nylon bush squeeze fit, seems its excessively undersized for purpose.
Does anyone have one they can take a look at?
First diameter 12.22mm, inner diameter 11.22mm versus base of an unfired factory 308win round, 11.80mm