Oldbloke wrote:Nothing wrong with singles. My single 12g seems to point OK.
Ya old prick.
Oldbloke wrote:Nothing wrong with singles. My single 12g seems to point OK.
juststarting wrote:Oldbloke wrote:Nothing wrong with singles. My single 12g seems to point OK.
Ya old prick.
juststarting wrote:in2anity, yeah I don't mind buying more powder... Will check 2207. I use 2205 and 2208 mostly. So something new would be good. I'll check out 2206H as well, could use that in my 223 too. Back to the drawing board.
H4895---48 to 52 gr's.
H4198---39 to 41 gr's.
IMR 4895--47 to 50 gr's.
IMR 3031---44 to 48 gr's.
RX-7---35 to 38 gr's.
sungazer wrote:IMR 4895 and H4895 are both the same AR2206H
juststarting wrote:Oi, mofos, go create a powder equivalents thread and have it out there. Don't hijack this one
Gamerancher wrote:20gr of 2205 used to work real well behind my 375gr cast bullets in .45-70 Marlin CB. Mild and accurate.
7gr of Trailboss in the .44rem mag and 16gr in the .45-70
juststarting wrote:Getting about 13.4 BHN. Guessing it may (or may not) harden a little more over a week. Acceptable hardness.
bigpete wrote:OK my load I came up with is a cbe 570gn gas check over 40gn ar2206h for 1470fps and around 27k psi. Standard disclaimer applies. Doesn't kick that bad
Tank wrote:bigpete wrote:OK my load I came up with is a cbe 570gn gas check over 40gn ar2206h for 1470fps and around 27k psi. Standard disclaimer applies. Doesn't kick that bad
I know this goes some way back Pete....but would like to know how you got on with you 570gr load here. No probs with stabilisation? Did it group ok? Did you slay a buff with it?
Cheers,
Tank.