New load for 300wm - Grouping results

[Australian_Patriot]

Hey guys,

Thought id check in with a range report, some of you 300wm shooters might be interested.

I have a Tikka T3 Varmint 300WM in an MDT Chassis. The below load of 5 shots grouped at .230" or just over half a centimetre at a 100m. Thought id try my luck at 414m for the 1st time, i ended up with a group of just under 3". I only managed to shoot off 3 rounds as opposed to my normal 5 for groupings.

Whats your thoughts? Is this a good group for a 300wm @ 400ms? Id welcome any feedback.

My load was:

175 SMK HPBT
PPU Brass
Fed 215 Primers
75gr 2213sc
Cases trimmed to 2.610
CBTO - 2.883 = 60thou off lands

1.jpg (1.32 MiB) Viewed 2332 times

2.jpg (1.59 MiB) Viewed 2332 times

[Jeff303]

Nice work mate, looks solid to me

[Member-Deleted]

"s**t 400 m ! ,I can't see that far"

Very good,well done.

[Supaduke]

Anything under 1inch per 100m is good shooting in my opinion. Especially in an outdoor environment.

[duncan61]

must recoil a bit ,I burn 64gn 2213sc with a 168gn matchking in 7mm and it boots

[duncan61]

I have looked up your load.Nice work.I use the 168 matchkings in my 7mm Rem Mag and they fly true.I will have a go at 400metres and post the results

[Xerox]

Definitely a good result

[Pilch]

Hey Patriot.

Just curious for comparison but did you try the same loads in the factory stock before switching to the MDT Chassis at all?