Help re Infiray TH50 scope.

[Die Judicii]

Being "old school" and used to good quality manual scopes that are a breeze to zero, adjust, etc, I have run into a brick wall.
After making the initial purchase and finding that I don't have a snowflakes chance in hell of zeroing it,, I got a cluey bloke from my local GS to do the job.
As an aside,,,,,, I love the clarity of this scope but that's it.
After getting it zeroed, I checked the performance.
A three shot group,, almost clovering,, but, exactly 26 mm to the left.

With a normal adjusting winding scope that would be a cinch to correct.

But,,,,, according to the manual, that would involve a minimum of eight (8) very confusing steps, to just move the point of impact by 26mm.
Bearing in mind that I cannot memorize which button or rotary encoder to turn/push/hold for whatever seconds.
Meanwhile, if not done correctly it reverts back to the beginning every time, before you can get it right.
FFS,,,,,,,,,,,,,, who designs such abominations

Does anyone know of a simple and less involved way these contraptions can be adjusted 26mm to the right ?

[bladeracer]

Being "old school" and used to good quality manual scopes that are a breeze to zero, adjust, etc, I have run into a brick wall.
After making the initial purchase and finding that I don't have a snowflakes chance in hell of zeroing it,, I got a cluey bloke from my local GS to do the job.
As an aside,,,,,, I love the clarity of this scope but that's it.
After getting it zeroed, I checked the performance.
A three shot group,, almost clovering,, but, exactly 26 mm to the left.

With a normal adjusting winding scope that would be a cinch to correct.

But,,,,, according to the manual, that would involve a minimum of eight (8) very confusing steps, to just move the point of impact by 26mm.
Bearing in mind that I cannot memorize which button or rotary encoder to turn/push/hold for whatever seconds.
Meanwhile, if not done correctly it reverts back to the beginning every time, before you can get it right.
FFS,,,,,,,,,,,,,, who designs such abominations

Does anyone know of a simple and less involved way these contraptions can be adjusted 26mm to the right ?

I don't know about simpler but you could use an adjustable mount and zero the scope using that instead of the scope adjustment.
https://www.extravision.com.au/collections/rifle-scope-mounts/products/click-adjustable-mount-zeroing-block

[straightshooter]

Unfortunately you will have to RTFI.