I have have a set of genuine CZ rings on my CZ527.
While doing a scope swap today. I snapped two of the screw heads in half.
They are just the flat screw driver. Slotted head style screw. I know why it happened. As a was undoing them I went the next flat blade screw head up. I thought it was a better fit. It was actually a bit big. Wedging the slotted head of the screw apart and snapping two of them. I got them out
Looks like Winchester Australia has replacement in stock. I’ll check with my LGS Monday. Not sure of cost.
I’d prefer a hex head or torx bit style screw? I have have searched but doesn’t look like a common thread/head size.
Just wondering if anybody else has been there done that?
Thanks