Baldrick314 wrote:Out of curiosity how much did the 650 set you back Brett?
A fraction under $2k5 fully pimped but not dies as I already had them.
XL650
Case feeder with sml & lge pistol plates
Quick change (toolhead & thrower)
Strong mount
Case gauges (9mm / 38Super)
Spare parts kit
Extra set of 4 pistol primer pickup tubes
Hornady LnL bullet feeder
3 dies for bullets (9mm, 38/357 & 44)
Kinchrome 26" Evolve 7 draw tool trolley
I used 12mm form ply to make a top for the trolley and screwed it down from the inside and mounted the press on top. All the case prep, bullet prep, reloading tools and dies are now in the one place with the top draw devoted to the gear needed to run the Dillon. Looking to do a similar thing with my other press so when I go bush for a week or more I can take my reloading gear with me which will vastly improve load development on the larger calibres. My cousins little Super Simplex press can't handle the cases I shoot.