Springfield model 56(by Stevens) cycle issue and easy fix

[SHV]

cycle the bolt but ammo jams half way into the chamber, bite off a piece of lead form projectile and sometimes if push too hard the case bent

[SHV]

IMG_4472.jpeg (159.49 KiB) Viewed 109 times

[SHV]

after a while i find out if hold the 10 round mag to cycle the bolt it fix the problem perfectly that means change the mag position(up) a little bit or change the angle a little bit will change the ammo's position or angle which is the cure

[SHV]

so I made a sleeve for the teen round mag and use a piece of patch glued in front part, it will adjust the angle of the mag once the mage installed

[SHV]

2R6A0575.JPG (573.23 KiB) Viewed 100 times

[SHV]

now no matter hold the mag or hold the rifle to cycle the bolt, no issue chambering the ammo anymore

2R6A0568.JPG (620.66 KiB) Viewed 97 times

[SHV]

2R6A0574.JPG (675.73 KiB) Viewed 89 times

also it's more comfortable to hold the mag when doing off-hand shooting
the original mag is steel 10 round one, it's too small and too sharp to hold to do off hand shooting