Yes mate, I did all the work myself and it's chambered in .308 Win.
Here is a list of the work I performed on this rifle;
Trigger job of 1 1/2 pound.
Lapped the bolt locking lugs, to thier abutments.
Re-crowned the muzzle and then, threaded muzzle to M16 x 1mm.
Machined and installed a proto-type quick discharge muzzle brake.
Inletted and epoxy bedded the synthetic stock. for the
http://www.lumleyarms.com , detachable magazine bottom metal.
Inletted and epoxy bedded the barreled action, into the synthetic stock (free floated barrel).
Fitted the third sling swivel stud, to the forward of action position.
Prepared and then Cerakoted (Sniper Grey) the stock, and then later, the barreled action, 0 degree scope base, etc (Coyote Tan, and Microslicked the bolt, inside and out, F/pin, cocking piece and F/pin spring).
Assembled every thing.
Fitted and lapped the TPS 30mm scope rings, and installed the Nightforce 2.5-10 x 42 scope.
Cleaned all the fouling from the barrel, and then Moly treated the bore, prior to shooting Moly coated bullets, in this barrel.
I think, that is about the exrent of it..................
Here is a group I shot with this same rifle, prior to the metal work, being Cerakoted (and with a 6.5-20 x 40mm scope on it).
- 018.JPG (546.67 KiB) Viewed 5113 times
D'oh!
Homer