Does anyone know what the OD of a flywheel "ring gear" is for a 1HZ Landcruiser motor 4.2 ??
Just the ring gear itself.
Die Judicii wrote:Does anyone know what the OD of a flywheel "ring gear" is for a 1HZ Landcruiser motor 4.2 ??
Just the ring gear itself.
bladeracer wrote:
Google says 275mm 108 teeth?
Is this for a tachometer sensor?
scoot wrote:1hz flywheel is pretty close to 360mm OD. The ring gear is slightly inset by a couple of mm though.
scoot wrote:If I remember I'll look in the bone yard tomorrow. There's probably some 1vd engines on the pile I can check too if you want.
scoot wrote:117 teeth on the 1hz flywheel about 355mm diam. Ring gear (dodgy measurement). 1vd-fte is the same, 117 teeth approx 355mm diam ring gear.
scoot wrote:An old 2h landcruiser may be 108 teeth but I haven't got any access to one of those old girls to check. 12ht is a bit like a unicorn here.