Larry wrote:They are the 40gn I was referring to.
Thanks. The driving band must be a thou or two further forward, or the nose is slightly over bore diameter, I'll have to measure them up.
All .22LR ammo is one-inch in length maximum.
Larry wrote:They are the 40gn I was referring to.
MtnMan wrote:just looked back through receipts. the CCI segmented HP subs is more expensive than the Eley.
Also from what I can gather the 40gr remington sub HP is no longer available. options are running out!
MtnMan wrote:out of all the high velocity stuff I've tried it shoots the best.
bladeracer wrote:Larry wrote:They are the 40gn I was referring to.
Thanks. The driving band must be a thou or two further forward, or the nose is slightly over bore diameter, I'll have to measure them up.
All .22LR ammo is one-inch in length maximum.
MtnMan wrote:does anyone in Australia sell a .22lr shell holder to fit an RCBS press?
I found an old towball that has the 7/8" thread that fits the press. wouldn't be too hard to machine a die out of it to swage a round nose into a HP. bit like the Waltz die.
MtnMan wrote:The CCI suppressor shot ok out of my gun, not quite as good as the Win super suppressed. the CCI is 970fps vs the 1090fps of the Win, both with 45gr bullet.
MtnMan wrote:Forgot to mention that the top and bottom groups respectively on each page correspond to the weight sorted batches.
MtnMan wrote:Forgot to mention that the top and bottom groups respectively on each page correspond to the weight sorted batches.
MtnMan wrote:I found a couple of mushrooms today also. The left one is a Winchester super suppressed 45gr DIY hollow point. It now weighs 44.9gr. the other one might be a Winchester power point or super speed HP.