Super Simplex help wanted

[Ferret57]

I am just entering into Reloading and have a Super Simplex that I was gifted. I have purchased a 4 die set in 9mm but there are no instructions as to what order I set these. Any help would be greatly appreciated.
I also purchased a 3 die set in 38 which was straight forward enough to set up but the 4th die in the 9mm has me stumped.

[bladeracer]

I am just entering into Reloading and have a Super Simplex that I was gifted. I have purchased a 4 die set in 9mm but there are no instructions as to what order I set these. Any help would be greatly appreciated.
I also purchased a 3 die set in 38 which was straight forward enough to set up but the 4th die in the 9mm has me stumped.

Is it a taper crimp die perhaps?

[Bugman]

I haven't loaded 9mm for a few years but I think I had a 4 die set up. 1. Resizing/decapping die. 2. Case mouth expansion.
3. Bullet seating die. 4. Factory crimp die. Maybe that is what you have. Hope you sort it out. Reloading is fun.

[Peter988]

Does this help ?

https://www.ssaa.org.au/wp-content/uplo ... ressed.pdf

I only have the decapping and bullet seating in mine.

[Ferret57]

Sorry for delay in responding to those helpful contributors your posts have got me out of a confused dilemma. I haven't worked out how to respond to individual posts so accept my thanks.

[Peter988]

I recently purchased a new die set for mine. I received the seating die, the de-priming die and the projectile seating die. This is for 223.

[Ferret57]

Peter 988 - same with the .38sp die set, only 3 dies so was simple enough to set up.